SEGES Innovation has changed their recommendation for the backfat thickness of sows and gilts at farrowing from 16-19 to 14-17 mm based on a data analysis containing >3,900 sows and litters from 10 feeding trials run over the past 6 years.
The analysis shows that sows having 12-20 mm backfat at farrowing are high producing. Furthermore, the analysis shows that lean sows have less body weight and backfat losses during lactation. Thus, aiming at leaner sows will result in a reduced feed amount needed for restoring the optimal body condition in the subsequent gestation.
The new recommendations have resulted in a change in the categorisation of sows into fat, normal, and skinny at weaning. A fat sow is characterised as having ≥ 15 mm backfat, a normal sow has 12-14 mm backfat, and a skinny sow has ≤ 11 mm backfat.
To track the development in body condition throughout the production cycle, and thereby, secure the sows are on the right feeding curve in the gestation unit, it is recommended to backfat scan the sows a minimum of three times per cycle; at weaning/mating, at 30 days in gestation, and at farrowing.
Backfat thickness is one of the important and practical parameters that pig producers use to determine the body condition of the gilts and sows in their herds – in order to select the best pigs prior to breeding. Over the years, the backfat measurement has been used more and more for managing the feeding curve, both in the gestation and the farrowing unit. Usually, the recommended backfat thickness is different among the different breeds and origins, but the shared principle is that neither too fat nor too skinny is good for production. Achieving the optimal backfat measurements for gilts and sows will help you maximise the genetic potential.
SEGES Innovation has worked for many years to find the optimal recommendations for the DanBred sow producers. Among other things, the genetic improvements during the recent years have led to a higher lean meat percentage in DanBred sows. This improvement have, in combination with improved feeding in the lactation period (with better feeding curves and adjusted protein and amino acid recommendations), resulted in a lower loss of body weight and less backfat losses during lactation than previously [1-3], why it was obvious that the backfat recommendations now needed an update – based on an analysis of more recent data – to set the new optimal backfat thickness at farrowing.
The data analysis done in 2021 was based on data originating from 10 feeding trials conducted in three different herds from 2016-2021 with a total of 3,919 DanBred sows and their litters [4]. The included sows were of parity 1st to 5th. Sows were standardised to either 12 (2 trials) or 14 piglets (8 trials) per litter. Sow body weight and backfat were registered at the time of litter standardisation and at weaning. Litter weight was registered at standardisation and at weaning. The weight of dead and removed piglets was registered to calculate litter gain. Sows were grouped in 10 groups according to backfat thickness at farrowing (Millimetre: 9-11, 12, 13, 14, 15, 16, 17, 18, 19-20, 21-26).
It was found that sow body weight and backfat loss increased linearly with increasing backfat thickness at farrowing (P<0.001). Sows with 9 mm backfat lost 1.2 mm backfat and 7.9 kg bodyweight, whereas, sows with 26 mm backfat lost 5.4 mm backfat and 18.4 kg body weight. As shown in Figure 1, the litter weight gain followed a quadratic pattern for both 1st (P=0.02) and 2nd-5th (P<0.001) parity sows. In the interval 12-20 mm backfat, the gain was 2.63-2.69 kg for 1st parity sows and 2.97-3.03 kg for 2nd-5th parity sows. For sows with 9 and 26 mm backfat, the average daily litter weight gain was lower and was at 2.51 kg and 2.48 kg for 1st parity sows, respectively, and 2.84 and 2.82 kg for 2nd to 5th parity sows.
Figure 1: Relationship between backfat thickness at farrowing and average daily litter gain for 1st (- – -) and 2nd – 5th (—-) parity sows
As shown in Figure 2, litter size at weaning also followed a quadratic pattern (P<0.01). Sows with 10-20 mm backfat weaned 12.7-12.8 piglets per litter, whereas sows with 26 mm backfat weaned only 12.3 piglets per litter. 5th parity sows with a backfat thickness of 9-11 and 12 mm had 15 % stillborn of total born compared to 10 % for sows with 13-26 mm backfat (P<0.05). Subsequent reproduction, i.e., the weaning-to-first-service interval, farrowing rate, and total born, was similar across all backfat thicknesses.
Figure 2: Relationship between backfat thickness at farrowing and litter size at weaning for 1st – 5th parity sows.
Based on these results, the recommendation onwards is to aim for a backfat thickness of 14-17 mm at farrowing for DanBred sows.
If the recommended feeding curves and nutritional requirements are followed, the production results will not be affected by the leaner sows. Even better, the sows will consume less feed while restoring optimal body condition compared to the previous recommendations, which means you will save feed costs.
It is recommended to evaluate the backfat thickness of sows and gilts three times per cycle. Sows that are evaluated as skinny at day 30 of gestation may need a fourth evaluation around day 60 of gestation to ensure a positive development of their body condition.
Recommended intervals for backfat scanning:
The backfat thickness is measured most efficiently by ultrasound at the P2 point as illustrated in Figure 3.
Figure 3: Procedure for ultrasound backfat scanning - in this case using a Lean-Meater.
At weaning, sows should be evaluated and categorised into “Fat”, “Normal” or “Skinny” based on the backfat measures [4].
Figure 5: Recommended feeding curves for sows and gilts during gestation
The recommended feeding curves in Table 1 have been adapted to reach the optimal 14-17 mm of backfat at farrowing. When following the feeding curves shown, most sows will be able to regain lost backfat during the first 30 days of gestation. However, it is important to follow the development among the sows throughout gestation to ensure that as many sows as possible are evaluated as being in the normal category (14 – 17 mm backfat) at the time of farrowing.
Table 1: Feeding curves in gestation, kg feed per day1
| Day in gestation | Body condition at weaning or at insemination (P2, mm) | |||
| Fat ≥ 15 mm |
Normal 12-14 mm |
Skinny ≤ 11 mm |
Gilts | |
| Prior to mating | After weaning and until mating all sows are fed 4.3 kg/day | |||
| 0-29 | 2.4 | 2.9 | 4.3 | 2.1 - 2.3 4 |
| 30-84 | 2.2 2 | 2.2 2 | 2.2 (3.3) 3 | 1.9 - 2.6 5 |
| 85-114 | 3.3 | 3.3 | 3.3 | 2.9 - 3.3 |
| 115 | 3.3 | 3.3 | 3.3 | 2.9 - 3.3 |
| Farrowing 6 | 3.3 | 3.3 | 3.3 | 2.9 - 3.3 |
You should aim for the recommended 14-17 mm backfat at farrowing. This will reduce the total amount of feed used during gestation, and thus, reduce feed cost for pig producers, without compromising lactation performance.
Remember to follow the development of the sows throughout gestation, by measuring backfat a minimum of three times per cycle; at weaning/mating, at 30 days in gestation, and at farrowing. This procedure will optimise the overall body condition of all sows, as feeding curves can be adjusted according to the sows’ actual needs, optimising the overall herd productivity.
[1] Hojgaard, C.K., T.S. Bruun, and P.K. Theil, 2019, Optimal crude protein in diets supplemented with crystalline amino acids fed to high-yielding lactating sows. Journal of Animal Science 97(8): p. 3399–3414.
[2] Hojgaard, C.K., T.S. Bruun, and P.K. Theil, 2019, Optimal lysine in diets for high-yielding lactating sows. Journal of Animal Science: p. 4268–4281.
[3] Strathe, A.V., et al., 2017, Increased dietary protein levels during lactation improved sow and litter performance. Animal Feed Science and Technology. 232: p. 169–181.
[4] Hojgaard, C.K. and T.S. Bruun, 2021, Baggrund for ændring af Anbefalet rygspæktykkelse hos søer omkring faring. SEGES Innovation, Den Rullende Afprøvning, Notat nr. 2130.